ASME Basic Ultrasonic Calibration Blocks for welds UT examination

Ultrasonic Calibration Block ASME Basic Calibration Block for UT examination of welds

Specifications:
Calibration blocks is an important supplementary material in the Ultrasonic testing, used to calibrate the sensitivity of the ultrasonic flaw detector and ultrasonic probe. Our testing block is certificated by the authority of the state depeartment. Our products include: domestic standards UT blocks, European standard UT block, NDT block, hexagonal testing block, and so on. Processing of the special specifications UT block.

It is used for establishment of primary reference responses for UT examination of welds, ASME Basic Calibration Block 1 contains three side-drilled holes at 38mm deep minimum at 2.5mm diameter, the hole locations through the thickness are 1/4,1/2 and 3/4 T. It also contains 2 EDM notches measuring 2% T deep*6.4mm max wide*25 long min. In accordance with ASME Sec V T-434.2. 

ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.